QMS 2425 Especificaciones Pagina 91

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 90
$ERXW+DUG
'LVNV
6WRUDJHDQG6FDQQLQJ'HYLFHV
»Note:
A Phillips screwdriver is needed for this procedure.
1 Position the controller board so that you’re looking at the
front of the interface panel.
2 Disconnect the serial cable, if previously installed.
Gently, pull straight up on the serial cable connectors to remove it
from the serial connector pins.
Caution:
Do not push or pull from the ribbon cable; use the cable
connector.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................
Vista de pagina 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 227 228

Comentarios a estos manuales

Sin comentarios