QMS 2425 Especificaciones Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
2SWLRQDO
1HWZRUN
,QWHUIDFH
406785%2 3ULQ W6\VWHP2SWLRQV
4 Attach the network interface card (NIC).
a Position the NIC so the port slides into the opening you just
created.
b Snap the NIC onto the 80-pin connector on the controller
board.
c Press down on the board gently until it is secured by the 80-
pin connector and by the plastic standoff post.
5 Replace the controller board.
Use the instructions in chapter 2 “Memory and System Software,”
the “Reinstalling the Controller Board” section, of this manual.
6 Secure the NIC to the printer with the two screws you
removed earlier.
7 Reconnect all interface cables and the power cord, and then
turn on the printer.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 227 228

Comentarios a estos manuales

Sin comentarios